Ak Interactive Pigment Fixer

AK Interactive Pigment Fixer is used to secure pigments applied to your model, preventing them from smudging or flaking off. Here’s how to apply it:

Preparation:

Ensure your model is completely dry after applying the pigments. This is crucial for proper adhesion of the fixer.
Choose your application method: You can apply the fixer by brush or airbrush.

Applying with a brush:

Shake the bottle of AK Interactive Pigment Fixer well before use.
Dip a clean brush into the fixer and gently dab it onto the areas where the pigments are applied. Avoid flooding the model or over-applying the fixer, as this can alter the pigment’s appearance.
Work in sections and allow each layer to dry completely before applying another. This ensures even coverage and prevents the pigments from being reactivated.

Applying with an airbrush:

Dilute the AK Interactive Pigment Fixer with AK Interactive Airbrush Thinner in a 1:1 ratio.
Fill your airbrush with the diluted mixture and adjust the pressure to a low setting (around 10-15 psi).
Spray the diluted fixer in short bursts onto the model, maintaining a distance of 10-15 cm. Similar to brush application, avoid over-saturation and work in thin layers.

Additional Tips:

Always work in a well-ventilated area and wear a mask when using the airbrush.
Test the fixer on a scrap piece of plastic or model sprue before applying it to your actual model. This helps you gauge the application effect and potential impact on the pigments.
Allow the final layer of fixer to dry completely before handling your model. This prevents accidental smudging or damage to the weathering effects.

Remember, practice and experimentation are key to mastering the use of AK Interactive Pigment Fixer for optimal results with your model weathering projects.